AGRI-COVER Command-10 Manual de instalación descargar pdf (Pagina 18)

STEP 16

Dual Pole Connector – Mount plug connector to suitable location

on semi-tractor, adjacent to existing plugs. Mount socket to

suitable location on trailer. Prep wires by stripping off insulation

as needed. On wires at socket, slide heat shrink tube over wire,

attach ring terminals and apply heat to shrink tubes. Bolt terminals

tight. On wires at plug, insert bare wires into plug tubes and secure

with set screws. See diagram below for detail assembly.

ELECTRIC WIRE ROUTING

Nut

Lock

Washer

Dual Pole

Socket

Dual Pole Plug

Select best routing for heavy gauge wire along frame towards

cab near existing wire harness and up to the battery. Install circuit

breaker in line on red(+) positive wire close to battery using 5/16”

ring terminals and heat shrink.

Prep end of heavy black wire for battery (-) negative post with

heat shrink tube and 3/8” ring terminal. Prep end of heavy red

wire for battery (+) positive post with heat shrink tube and 1/2” ring

terminal. Do not connect wires to battery now.

Figure 16

NOTE: If installing on trailer with existing electric tarp skip to step 17.

Strip Wire Insulation

Off As Needed

Red (+) Wire To (+)

Battery Terminal

Phillips Head

Screw At End Plug

Flat

Washer

Use Set SCREW

To Anchor Wire To

Plug Receptacle

Insert Wire

Retainer

Clip In Plug

As Shown

Thread Cutting Bolt 2x,

If Unable To Use Nut

Behind Frame Drill 1/4”

Hole And Turn Thread

Cutting Bolt Into Frame

Loosen Set Screws Slide

Bare Wire Into Tubes –

Turn Both Set Screws

Tight Into Each Bare Wire

Bolts

For Ring

Terminals

Heat Shrink

Tube

Red Wire To Terminal

2 On Motor and

Terminal 2 on Remote

Control Box

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 24

Comentarios a estos manuales

Sin comentarios

AGRI-COVER Command-10 Manual de instalación Pagina 18

Comentarios a estos manuales

Relacionado con productos y manuales para Controles remotos AGRI-COVER Command-10