AGRI-COVER Command-10 Manual de instalación descargar pdf (Pagina 22)

WIRING ADDITIONAL ELECTRIC HOPPER BOTTOMS

Figure 19

Note: Use dielectric grease

(packet included) at all

electrical connections.

WIRE SCHEMATIC

BATTERY

REMOTE

CONTROL

BOX 1

REMOTE

CONTROL

BOX 2

MOTOR

Bat (-) Black Bat (-) Black

(-) Black

Bat (+) Red

(+) Red

Red Motor 2

Black Motor 1

Dual Pole

Connection

Black Motor 1

Red Motor 2

From Control Box 1

40 AMP

Breaker

Aux

(-) Black

(+) Red

Bat (+)

Heavy Gauge Wire

ELECTRIC MOTOR OPERATING INSTRUCTIONS

NOTE: Electric hopper system is equipped with an automatic circuit

breaker. Holding switch until circuit breaker trips is TOO LONG. To reduce

unnecessary strain on components, always release switch before circuit

breaker trips.

Note: Remote will come pre-programmed from the factory. Remote control

boxes will come numbered to coincide with programmed modes of remote.

Refer to Command-5 owner’s manual or the remote programming video at

www.agricover.com/rolltarps/videos for re-programming and directions to

program multiple remotes and receivers.

1: CLOSING HOPPER FROM OPEN POSITION

Push switch to the CLOSED position and hold. Visually view hopper gate position

and release switch when hopper gate is fully closed.

2: OPENING HOPPER FROM CLOSED POSITION

Push switch to the OPEN position and hold. Visually view hopper gate position

and release switch when hopper gate is at desired location.

1 2 ... 17 18 19 20 21 22 23 24

Comentarios a estos manuales

Sin comentarios

AGRI-COVER Command-10 Manual de instalación Pagina 22

Comentarios a estos manuales

Relacionado con productos y manuales para Controles remotos AGRI-COVER Command-10